Telnet is disabled by default in your NAS, you should leave it this way. Telnet protocol is completely insecure, and should never be accessible from outside your network. Please do NOT Port-Forward port 13131/TCP to your NAS from the Router. For example, to access the administration interface of Turbo NAS series, you need to open port 8080. You may select the services with the corresponding port numbers to be opened on the router for Internet access. This function is available on most routers in the market and is often known as "Port Forwarding", "NAT Server", or "Virtual Server". If your NAS is located behind the NAT router, you need to open the port numbers on the router for remote access to the NAS. QNAP Tutorial: Set up DDNS Service for Remote Internet Access to QNAP NAS wrote: Port Forwarding If you need help with your Port-Forwards you might want to start with the following: This why Steve Gibson's GRC.com, and the FBI recommend disabling this feature anyway. I huge number of Consumer Routers do not implement UPnP-IGN properly, basicly turning networks into Open Relays for Hackers to control at their whim. Simply check the port requirements of your NAS, and any Apps (QPKGs) you have installed, and setup the forwarding manually. You would be far safer to disable any UPnP features that are supported on your Router, and simply setup manual Port-Forwards, and Port-Range-Forwards yourself. (My kids and girlfriend aren't completely Computer savvy, so I don't want them downloading Viruses or other Malware that will harvest information from my network, and be able to " call back to Mother ship" to deliver my data to their archives for further analysis). In my case, my Router used to support it, but I completely disabled it deliberately! I have no desire for any Router feature that allows software inside my network to setup up Port-Forwards without my knowledge or consent. " Good" Routers typically don't support UPnP-IGN at all. What do you QNAP brainy-acks think of this solution? Then the new router can associate with QNAP using UPnP. Then set the ATT to DMZ so all it's ports are open. So I was thinking that a slick solution would be to purchase a "good" router that supports UPnP and connect it's WAN port to a LAN port on the ATT dsl router. Finding the correct ports to to open is not clearly mentioned on the Qnap site or this forum and so far has been a bust. Drdbrown wrote:My ATT dsl modem/router does not support UPnP so myQNAPcloud service has failed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |